Snow-retention Components Further Slow Snow from Sliding Off a Roof

SnapClip II from S-5!SnapClip II from S-5!

SnapClip II from S-5!

SnapClip II from S-5!

SnapClip, SnapClip II or SnapClip III are optional components that can be added to your S-5! ColorGard snow retention system to further retard the migration of snow. It has a special integrated rubber “foot” to prevent abrasion of the panel’s finish. SnapClip snaps onto the back of the crossmember and extends down to the flat of the roofing panel.

Snap the SnapClip onto your ColorGard crossmember after installation. One or two clips are used between seams. Mount the SnapClip to the back of the crossmember using the lock that results with the rubber “foot” resting properly on the panel surface. When applying downward pressure on the part, the “toe” should engage the surface of the panel just before the “heel.” Screw SnapClip into place utilizing the provided stainless steel self-tapping screw.

SnapClip II has two locks and is especially made for seam heights of 1 inch (25 mm) and 1 3/4 inch (44.5 mm) snap. It will also fit 2-inch (51 mm) vertical seams but not 2-inch (51 mm) horizontal.

SnapClip III has three different locks and will work on seam heights of 1 3/4 inch (44.5 mm) up to 3 inches (76 mm).

SnapClip should not be used on copper roofs.

Be the first to comment on "Snow-retention Components Further Slow Snow from Sliding Off a Roof"

Leave a Reply