One-piece Clamp Fits Standing-seam Panels with Horizontal Seams

The S-5-H90 is a one-piece clamp that was developed to accommodate metal roof panels with a horizontal seam greater than 0.65 inch.The S-5-H90 is a one-piece clamp that was developed to accommodate metal roof panels with a horizontal seam greater than 0.65 inch.

The S-5-H90 is a one-piece clamp that was developed to accommodate metal roof panels with a horizontal seam greater than 0.65 inch.

The S-5-H90 is a one-piece clamp that was developed to accommodate metal roof panels with a horizontal seam greater than 0.65 inch.

The S-5-H90 is a one-piece clamp that was developed to securely and cost‑effectively accommodate metal roof panels with a horizontal seam greater than 0.65 inch.

Turning the clamp 90 degrees so that the bolt hole side is facing up, slip the clamp on the seam and tighten the setscrews. Go to the S-5! website for information about properly attaching S-5! clamps. After the clamp is installed, affix ancillary items using either of the two threaded bolt holes and bolt provided. The S-5-H90 is perfect for use with S-5! ColorGard and X-Gard snow retention systems and other heavy-duty applications.

The S-5-H90 Mini is a bit shorter than the S-5-H90 and has one setscrew and one threaded bolt hole rather than two. The mini is the choice for attaching all kinds of rooftop accessories: signs, walkways, satellite dishes, antennas, rooftop lighting, lightning protection systems, solar arrays, exhaust stack bracing, conduit, condensate lines, mechanical equipment—just about anything!*

The S-5-H90 and S-5-H90 Mini clamps are each furnished with the hardware shown to the right. Each box also includes a bit tip for tightening setscrews using an electric screw gun. The structural aluminum attachment clamp is compatible with all common metal roofing materials excluding copper. All necessary stainless steel hardware is included. Please visit www.S-5.com for more information including CAD details, metallurgical compatibilities and specifications.

The S-5-H90 clamp has been tested for load-to-failure results on a variety of horizontal standing seam roof profiles from leading panel manufacturers. The independent lab test reports can be found on the company’s website.

Be the first to comment on "One-piece Clamp Fits Standing-seam Panels with Horizontal Seams"

Leave a Reply